Drive Unit Assembly |
|
Locate the motor mount on your end cap, leaving a small gap between the top of the motor mount and the inside edge of the end cap. |
Use a long drill bit to locate the holes for the mounting bolts and the drive shaft. Use a 3/16" drill bit for locating the drive shaft hole. Use a 1/8" drill bit for locating the mounting bolt holes. |
Drill and tap the holes for the mounting bolts. Drill the hole for the drive shaft seal. |
Note the locations of the shaft seal and motor mount bolt holes directly above it. |
This photo shows the shaft seal in place. |
This photo shows the Motor, Drive Unit and shaft seal assembled to the end cap. |